General Power supply 200-240 V AC, 50/60 Hz Power consumption 1,850 W (18 W with standby mode) LCD panel Panel size 46 mm (1.8 inches) diagonal (4:3 aspect ratio) Display method Transparent LCD panel (x 3, R/G/B) Pixels 786,432 (1,024 x 768) x 3, total of 2,359,296 pixels Pixel configuration Stripe Pure color control device 1 Lens Optional Lamp 380 W x 4, lamp replacement cycle (lamp power: Normal/Eco1, Eco2): 2,000 hours/3,000 hours1 Screen size (diagonal) 1.02–15.24 m (40–600 inches) (2.54–15.24 m [100–600 inches] with the ET-ELS03), 4:3 aspect ratio Brightness2 16,000 lm (4-lamps, lamp power: Auto/Normal, Optional lens: ET-ELS03) Center-to-corner uniformity2 90 % Contrast2 2,500:1 (full on/full off, 4-lamps, lamp power: Auto) Resolution 1,024 x 768 pixels (Input signals that exceed this resolution will be converted to 1,024 x 768 pixels.) Scanning frequency HDMI/DVI-D Horizontal: 26–80 kHz, vertical: 23–85 Hz, dot clock: 162 MHz or lower RGB (analog) fH: 15–120 kHz, fV: 48–120 Hz, dot clock: 230 MHz or lower (Signals exceeding the dot clock rate of 165 MHz are downsampled.) YPBPR (YCBCR) fH: 15.75 kHz, fV: 60 Hz [480i (525i)]
fH: 31.50 kHz, fV: 60 Hz [480p (525p)]
fH: 45.00 kHz, fV: 60 Hz [720 (750)/60p]
fH: 33.75 kHz, fV: 60 Hz [1035/60i]
fH: 28.13 kHz, fV: 50 Hz [1080 (1125)/50i]
fH: 28.13 kHz, fV: 50 Hz [1080/25sF]
fH: 27.00 kHz, fV: 48 Hz [1080/24sF]
fH: 33.75 kHz, fV: 60 Hz [1080/30sF]
fH: 56.25 kHz, fV: 50 Hz [1080/50p] Video/S-Video fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60],
fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM] Optical axis shift With the ET-ELW06: vertical ±39% from center of screen (powered)*3
With the ET-ELW02/ELW04/ELS03/ELM01/ELT02/ELT03: vertical ±39%, horizontal ±10% from center of screen (powered)
With the ET-ELS02: vertical ±50%, horizontal ±10% from center of screen (powered)
With the ET-ELW03: the optical lens shift function cannot be used. Keystone correction range Vertical: Maximum ±40°, Horizontal: Maximum ±40°
(with XGA signal input, for vertical/horizontal correction only, Optional lens: ET-ELS03) Installation Ceiling/floor, front/rear Terminals INPUT1 - DVI-D IN DVI-D 24-pin x 1
(DVI 1.0 compliant, compatible with HDCP, compatible with single link only), 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1035/60i, 1080/24p, 1080/24sF, 1080/25p, 1080/25sF, 1080/30p, 1080/30sF, 1080/60p, 1080/50p, VGA (640 x 480)–WUXGA (1,920 x 1,200)*4,
compatible with non-interlaced signals only, dot clock: 25–162 MHz INPUT1 - HDMI IN HDMI 19-pin x 1
(compatible with HDCP, compatible with Deep Color), 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1035/60i, 1080/24p, 1080/24sF, 1080/25p, 1080/25sF, 1080/30p, 1080/30sF, 1080/60p, 1080/50p, VGA (640 x 480)–WUXGA (1,920 x 1,200)*4,
compatible with non-interlaced signals only, dot clock: 25–162 MHz INPUT1 - ANALOG IN D-sub HD 15-pin (female) x 1 (RGB x 1) INPUT2 - RGB 5BNC IN/ VIDEO IN BNC x 5 (RGB/YPBPR/YCBCR x 1), shared with VIDEO IN (BNC x 1) (composite video) INPUT2 - S-VIDEO IN Mini DIN 4-pin x 1 (S-Video) INPUT3/INPUT4 Optional interface board slot, When the ET-MD16SD1 is installed,
SERIAL IN (SDI IN 1/2): BNC x 2 (SD-SDI signal/single link HD-SDI signal)
SD-SDI signal (YCBCR 4:2:2 10-BIT): 480i, 576i (SMPTE 259M-C compliant)

Single-link HD-SDI signal (YPBPR 4:2:2 10-BIT): 720/50p, 720/60p, 1035/60i, 1080/50i, 1080/60i, 1080/25p, 1080/25sF, 1080/24p, 1080/24sF, 1080/30p, 1080/30sF (SMPTE 292M compliant)
SERIAL OUT (SDI OUT): BNC x 1 (active through) SERIAL IN D-sub 9-pin (male) x 1 for external control SERIAL OUT D-sub 9-pin (male) x 1 for link control REMOTE IN M3 Jack x 1 (for wired remote control) LAN RJ-45 x 1 (for network connection, 100Base-TX/10Base-T, compliant with PJLink™ [class1]) USB USB type-B (USB connector) x 1*5 Cabinet materials Molded plastic Dimensions (W x H x D) 650 x 349 x 815 mm (25.6” x 13.7” x 32.1”)
(with legs at shortest position, optional lens not included) Weight Approximately 46.5 kg (102.5 lbs)
(optional lens not included) Noise level 51 dB (lamp power: Normal/Eco2),
48 dB (lamp power: Eco1) Operating temperature 5°C- 40°C 41°F-104°F,
5°C- 30°C 41°F-86°F Operating humidity 20–80 % (no condensation) Supplied accessories Power cord x 1 (x 2 for PT-EX16KE/EX12KE), power cord holder/power cord cover x 1set, wireless/wired remote control unit, batteries (AAA/R03/LR03 type x 2), VGA cable x 1, software CD-ROM (Logo Transfer Software, Multi Projector Monitoring & Control Software, Real Color Manager Pro.), lens attachment x 1set, lens lock lever fixing bracket x 1set, lightshielding plate x 3set, spacer x 1set, cable tie x 3 NOTE *1 The values given for the recommended lamp replacement cycles are maximum.

• 2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.
• 3 The ET-ELW06 is equipped with only vertical optical axis shift.
• 4 Compliant with VESA CVT-RB.
• 5 This port is for use by service personnel only. The USB interface may not operate with all USB